攪拌車篩網葉片出現故障需及時維修
篩網故障是混凝土自上料攪拌車的常見故障，當然這需要進行及時的維修，否則會對后面的施工造成很大的影響，下面來講講維修內容吧。
Screen fault is a common fault of concrete self loading mixer truck. Of course, it needs to be repaired in time, otherwise it will have a great impact on the later construction. Let's talk about the maintenance content below.
由于篩網采用普通鋼材，經常存在質量差、耐磨性差的問題，包角不夠合理，因此在應用過程中容易損壞，出現大面積滲漏，甚混音器也無法使用。
Because the screen is made of ordinary steel, there are often problems of poor quality and poor wear resistance, and the wrap angle is not reasonable enough. Therefore, it is easy to be damaged in the application process, large-area leakage occurs, and even the mixer can not be used.
另外，有些攪拌篩的目數不夠科學，篩分率太低，導致已篩分的砂石粒度小。如果攪拌機的篩網尺寸不夠合理，鋼材質量不達標，那么再的攪拌機也無法攪拌出高質量的混凝土。
In addition, the mesh number of some mixing screens is not scientific enough, and the screening rate is too low, resulting in small particle size of screened sand and stone. If the screen size of the mixer is not reasonable enough and the steel quality does not meet the standard, the most advanced mixer can not mix high-quality concrete.
攪拌機篩網故障維修中應使用耐磨鋼絲，設置科學的鋼絲直徑和篩網目數，適當增加篩網的有效面積，提高篩分率，節約原料，從而提高生產效率。發現篩線斷線后，立即擰緊篩網螺栓，重新設置篩網長度。
Wear resistant steel wire should be used in the maintenance of mixer screen fault, set scientific steel wire diameter and screen mesh, appropriately increase the effective area of screen, improve screening rate and save raw materials, so as to improve production efficiency. When the screen wire is broken, immediately tighten the screen bolt and reset the screen length.
此外，葉片故障也是一個重大故障。葉片作為攪拌機設備的重要部件之一，對攪拌過程有著直接的影響，葉片的好壞在一定程度上可以決定攪拌機的使用壽命。因此，在攪拌機使用過程中，葉片的損壞程度往往比較高，因此需要注意葉片修復技術。
In addition, blade failure is also a major failure. As one of the important parts of mixer equipment, blade has a direct impact on the mixing process. The quality of blade can determine the service life of mixer to a certain extent. Therefore, during the use of the mixer, the damage degree of the blade is often high, so attention should be paid to the blade repair technology.
攪拌機每次攪拌完畢后，需要立即清洗攪拌機的葉片，以便及時葉片上的污垢。攪拌機的葉片和振動軸承應滴上潤滑油，攪拌機的葉片應防銹除銹。
After each mixing of the mixer, the blades of the mixer need to be cleaned immediately to remove the dirt on the blades in time. The blades and vibration bearings of the mixer shall be dripping with lubricating oil, and the blades of the mixer shall be rust proof and derusted.
混凝土自上料攪拌車廠家認為，定期檢查攪拌機的葉片手柄和葉片焊接質量，檢查葉片磨損和消耗情況。一旦發現異常問題，應及時記錄并更換，并檢查刀片底部導通狀態，避免刀片損壞。泄漏發生在焊點處。
The manufacturer of concrete self loading mixer believes that the welding quality of the blade handle and blade of the mixer shall be checked regularly, and the blade wear and consumption shall be checked. Once any abnormal problem is found, it shall be recorded and replaced in time, and the conduction state at the bottom of the blade shall be checked to avoid blade damage. Leakage occurs at the solder joint.
混凝土自上料攪拌車作為重要的建筑工程機械，在具體應用的過程當中需要從各個角度對其進行科學合理的保養以及維修，從而確?；炷磷陨狭蠑嚢柢嚨恼＿\轉使用。更多信息就來網站ablank.cn咨詢吧。
As an important construction machinery, concrete self loading mixer needs scientific and reasonable maintenance and repair from all angles in the process of specific application, so as to ensure the normal operation of concrete self loading mixer. For more information, please visit ablank.cn Consult. Com.
