混凝土攪拌車翻車現象頻發是怎么回事？
混凝土攪拌車翻車現象頻發是怎么回事？
What is the frequent turnover of concrete mixer truck?
在攪拌車發生的事故中，很大一部分都是翻車原因造成的，混凝土攪拌車屬于專用車，它跟普通的貨車是不一樣的，很多人開得了大貨車，駕駛攪拌車還是有點困難的，中科聚峰總部先說說它吧，攪拌車是近十年左右新興起的一種車型，它的相對較高，跟普通貨車的駕駛方法是有區別的。那么導致攪拌車翻車的具體原因有哪些呢？
In the accidents of mixer truck, a large part is caused by rollover. The concrete mixer truck is a special vehicle, which is different from the ordinary truck. Many people can drive a large truck, but it is still a little difficult to drive the mixer. Let's talk about it first in the headquarters of Zhongke Jufeng. The mixer is a new type of vehicle in the past ten years or so. Its center of gravity is relatively high, and it is ordinary There are differences in the way trucks are driven. So what are the specific reasons for the truck to overturn?
1.駕駛員的操作不當，攪拌車較高，且在行駛途中，攪拌罐是處于勻速轉動的狀態，假如遇到轉彎或者路況不好的情況下，控制不好車速和轉速就容易導致攪拌車翻車，新手攪拌車司機要掌握好車速。
1. If the driver's operation is improper, the center of gravity of the mixer is high, and the mixing tank is in a state of constant speed rotation during driving. If you encounter turning or bad road conditions, poor control of the speed and speed will easily cause the mixer to overturn. The novice mixer driver should grasp the speed.
2. 路況惡劣，攪拌車一般都是從攪拌站裝上混凝土，再運送到建筑工地上去，由于混凝土對環境有污染，所以攪拌站一般都是建立在比較偏僻的地方，所以有的地方路況不是很好，攪拌車整車滿載時，在駕駛過程中加上路況不好，稍不注意就有可能造成翻車，如果自己的駕駛技術不熟練，對于這種路況的活兒好不要接
Two The road conditions are bad. The mixer truck is usually loaded with concrete from the mixing plant and then transported to the construction site. As the concrete pollutes the environment, the mixing plant is generally set up in remote places. Therefore, the road conditions in some places are not very good. When the mixer truck is fully loaded and the road condition is not good during driving, it may cause rollover if you do not pay attention to it I'm not proficient in driving, so I don't have to take on the work in this kind of road condition
3. 怎么樣才能避免翻車呢？攪拌車在重載時要注意，發動機轉速好在1000-1400轉/分范圍內工作，這樣發動機擁有大扭矩，在運送混凝土的過程中，車速好控制在40km/h，這樣才能大程度的保證行車，在轉彎之前要將車速降下來，然后再轉彎，攪拌車在裝運攪拌好的混凝土時，攪拌罐的轉速為2-10轉/分，在運輸過程中，比較平坦的額路面上攪拌罐的轉速要保持在2-3轉/分，行駛在側傾坡大于50度的路面，或左右晃動較大的路面時，應停止攪拌罐轉動，等路況好轉后在恢復轉動。
3. How to avoid rollover? When the mixer truck is under heavy load, it should be noted that the engine speed should be within the range of 1000-1400 rpm, so that the engine has a large torque. In the process of transporting concrete, the speed should be controlled at 40km / h, so as to ensure the driving to a large extent. Before turning, the speed of the mixing tank should be 2-10 when the mixing truck is transporting the mixed concrete In the process of transportation, the rotation speed of the mixing tank should be kept at 2-3 rpm on the relatively flat road surface. When driving on the road with a roll slope greater than 50 degrees, or on the road with large left-right shaking, the rotation of the mixing tank should be stopped, and the rotation can be resumed after the road conditions improve.
感謝您的閱讀，希望對您有所幫助！如想了解更多內容歡迎點擊中科聚峰總部http://ablank.cn網站。
Thank you for your reading and hope it can help you! If you want to know more, please click the headquarters of Zhongke Jufeng http://ablank.cn Website.
